- 1). Remove the two screws on the top of the base toward the front of the Envirovac.
- 2). Lift up the brush roller cover and remove it.
- 3). Lift out the end of the brush roller that is not connected to the belt. Lift up the other end to loosen the belt.
- 4). Slide the belt off of the brush roller. Unhook the other end of the belt from the motor shaft.
- 5). Thread the new belt around the brush roller. Hook the other end onto the motor shaft.
- 6). Insert the left end of the brush roller into the Envirovac. Pull the other end of the brush roller slightly away from the motor shaft to stretch the belt until the brush roller can be fully inserted.
- 7). Replace and reposition the brush roller cover. Insert the two screws that hold the cover in place.
previous post